Do it yourself
| ||||
|
Citroen C3 - Video tutorial
Model: Citroen C3
FC, FN
- Years 2002-2009 If it happens that while adjusting the speed of the passenger compartment fan, it does not activate only at maximum speed, then it means that the rheostat (ie the resistor) that controls the rotation speed of the fan control motor has been damaged; It is a very common defect on many models of the French house but which can be solved quickly and also quite cheaply (cost of replacement about 40.00 euros); to replace the resistor which is located immediately behind the center console and has a green terminal block, attached to the fan motor, you do not have to remove any element of the dashboard but just access from the passenger side, unscrew the fixing screws and disconnect the sockets .
Posted on 13 September 2023 by ScegliAuto
Other guides that may interest you |
Frequently Asked QuestionsHow to reset the TPMS light of the Volkswagen Polo 2011The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.030
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |