Do it yourself
Frequently asked questions about cars and motorcycles

Changing the Engine Oil and Filter on the Citroen C3

Model: Citroen C3 FC, FN - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009
Part: Engine oil

See other generations:
Video tutorial

Follow these steps to replace the engine oil and filter on the Citroen C3. Open the bonnet and unscrew the oil filler cap, then remove the dipstick. Using a ratchet wrench with an extension and a 27 mm socket, unscrew the oil filter cover after placing a container to catch the used oil. Cover the area with a cloth to prevent dirt from entering.

Lift the car using a jack or ramp, unscrew the oil drain plug after placing a collection container underneath, and allow the old oil to drain. Take the filter cover and remove the old filter element and rubber seal, clean it with a suitable cleaner, and insert the new filter and new O-ring, applying a thin layer of oil on the seals.

Refit the new filter into its housing and tighten the cover with a torque wrench to 250 Nm. Screw in the drain plug with a new seal, tightening it with a torque wrench to 30 Nm. Pour approximately 3.5 litres of engine oil into the filler cap and check the level with the dipstick.

Start the engine until the oil pressure warning light goes out. Check the level again and top up if necessary.


Updated on 9 September 2026 by ScegliAuto


Related tutorials

Citroen C3 (2002-2009 / FC, FN) Carrying out the regular maintenance service is really very simple; let's see how to replace the engine oil and oil filter of the Citroen C3. First, …
Citroen C3 (2002-2009 / FC, FN) Today, learn how to replace the engine oil and oil filter while performing the routine maintenance service on the Citroen C3 HDI. First, lift the veh…
Citroen C3 (2002-2009 / FC, FN) Watch this short video to learn how to remove and replace the oil filter cartridge on a first-generation Citroen C3 with a 1.4 HDI engine. Before pro…

Other guides you may be interested in

How to Reset the Tyre Pressure Warning Light on the Jeep Renegade?

To reset the tyre pressure warning light on the Jeep Renegade, inflate the tyres until they reach the recommended pressure: this value is indicated on the sticker attached to the driver’s door pillar. Once the tyres are properly inflated, navigate through the menu that appears on the instrument cluster until you find the tyre pressure option. At this point, press and hold the OK button on the right side of the steering wheel to make the warning light disappear.

Watch the video!


by ScegliAuto

More videos