Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Citroen
    3. :
  3. C5
    4. : How to reset the Citroen C5 sevice warning light

Citroen C5 - Video tutorial

Model: Citroen C5 RD, MK 2, X7 - Years 2008-2017
Part: Instrument cluster
Operation: How to reset the Citroen C5 sevice warning light

If the service warning light comes on on the instrument panel display when the ignition is switched on, it means that it is time to carry out maintenance, either due to mileage reached or due to time limit; in both cases it is therefore necessary to first proceed with maintenance by replacing the engine oil, the relative filter and perhaps also the other filters, and then reset the warning light; this procedure is manual and does not require the aid of diagnostic instruments; in fact, just sit in the driver's seat, close all the doors and the ignition is off, press and hold the ODO button under the instrument panel display and then turn on the ignition: the countdown will then appear at the end of which release the button and turn off the ignition .


Posted on 21 September 2023 by ScegliAuto

Other guides that may interest you

    Frequently Asked Questions

    • C5 2008-2017 - What to do when the AdBlue light comes on in a Citroen C5? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos