Do it yourself
| ||||
|
Dacia Duster - Video tutorial
Model: Dacia Duster
HS, MK 1
- Years 2010-2017 For the low beam bulbs (H7) of the Dacia Duster we must, first of all, open the front hood of the engine compartment from which we access the rear part of the headlights whose bulbs we want to replace. Once this operation has been carried out, we can remove the rubber cap which serves to protect the electrical contacts from water and humidity. In this way, we proceed to extract the dipped beam bulb, H7, from its housing (to do so, it must first be pushed down until you hear a click) and disconnect its power supply by unplugging the appropriate plug. Now we can replace the bulb with the new one and proceed to insert it into place with one of the tabs facing up. Insert the lower part first and then push up until you hear a click. From this position we can also access the other headlight bulbs that can be replaced with similar procedures. Let's put everything back in place by going backwards.
Posted on 25 October 2023 by ScegliAuto
How to replace headlight bulbs on Dacia Duster
Dacia Duster (2010-2017 / HS, MK 1) Let's see how to remove the headlight bulbs on a Dacia Duster: open the front hood by pulling the lever located at the bottom right of the dashboard,
How to replace the bulbs on the Dacia Duster
Dacia Duster (2010-2017 / HS, MK 1) .. Let's see how to replace the headlight bulbs of the Dacia Duster. We open the front hood by pulling the lever located..
Disassembly of the headlight of the Dacia Duster MK1
Dacia Duster (2010-2017 / HS, MK 1) In this video we will see the steps on how to remove and replace the headlights on the Dacia Duster first series. First we open the bonnet and start Other guides that may interest you
|
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.071
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |