|
Do it yourself
| |||
| ||||
How to check the fluid levels of the Dacia Jogger
Model: Dacia Jogger
MK 1
- Years 2021-2026
Let's see how to check the fluid levels in our Dacia Jogger. We open the hood, and with the engine cold, we start by checking the engine oil level, identified by a yellow ring. We remove the dipstick, clean it with a lint-free cloth, reinsert it completely, then remove it again and read the level, which should be below the "max" mark. If it is low, we top up with more oil of the same specification recommended in the manual, by opening the oil cap and adding a little at a time, being careful never to exceed the maximum level. We then check the coolant level, through the semi-transparent sides of the reservoir. Here too, the level should be between "min" and "max". If necessary, top up with fluid of the same color as that in the reservoir. The brake fluid is found in a rather small reservoir near the windshield, visible through the walls of the reservoir. In theory, brake fluid does not get consumed: if it decreases, it means the brake pads are worn out. We top up the oil but plan on replacing the brake pads. In one corner of the engine compartment, we find a reservoir with a blue cap: there is the windshield washer fluid, which should always be filled to the brim with the specific fluid, not tap water, which can freeze in winter and cause damage with limescale.
Posted on 12 September 2025 by ScegliAuto
Video tutorial
Related tutorials
Dacia Jogger
(2021-2026 /
MK 1)
If you own a Dacia Jogger and are wondering what the correct procedure is to complete the manual reset of the tyre warning light, just read the follo…
Dacia Jogger
(2021-2026 /
MK 1)
Locating the OBD2 port on your Dacia Jogger (2022 model) is very simple, just follow the steps outlined in this guide. First, open the driver's side …
Dacia Jogger
(2021-2026 /
MK 1)
In order to replace the cabin filter of the Dacia Jogger, you need to completely remove the trim panel located on the side of the footwell from the f…
Other guides you may be interested in
|
How to Open a Stuck Boot on the Peugeot 407?
On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.855
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |