How to Change the Engine Oil and Filter of the Dacia Sandero

On the Dacia Sandero, changing the oil is performed safely on level ground, with the engine off and the car properly supported. If you want to use a cleaning additive before the change, add it to the old oil through the upper filler neck and let the engine idle for a short time, then turn it off and proceed with the drain.

Before starting, prepare a large container, gloves, and goggles, as the oil can be hot. Access the underbody and clear the work area: if there is a lower protection, open the service hatch or remove the necessary part to reach the sump. Position the container under the drain plug, loosen the plug, and allow the oil to drain completely.

When the flow has stopped, replace the plug using the correct seal if required by your model and tighten securely without forcing the threads. Next, move on to the screw-on oil filter.

Locate the filter, loosen it with a filter wrench if necessary, and complete the removal by hand, keeping the filter upright to avoid spillage. Check that the old seal does not remain stuck to the seat, clean the mating surface, and prepare the new filter by lightly lubricating the seal with a thin layer of clean oil. Screw the filter on until it is seated and complete the tightening by hand according to the replacement part's instructions, without using levers or excessive force.

Return to the engine bay, pour in the new oil according to the specifications and quantity indicated for your engine, then close the cap. Start for a few seconds, turn off, and wait for settling, then check the level with the dipstick and correct with small additions until the correct level is reached.

Conclude by checking for any leaks around the drain plug and filter.