Do it yourself
Frequently asked questions about cars and motorcycles

How to Remove the LPG Injectors from a Dacia Sandero

Model: Dacia Sandero B8 - Years 2012-2020
Part: Fuel injectors

This video shows how to remove and clean the injectors of a Dacia Sandero LPG with a 1.0 3-cylinder engine and Landi Renzo Eco Evo P-MX D6 GF50 system. Start by disconnecting the central intercooler hose: you will need to push and pull to remove it. Next, loosen the LPG injector wiring (and connectors, one for each cylinder) with a screwdriver. Remove the central screws of the rail: 1 screw of 8 mm (behind a bar, to be removed with a 10 mm spanner) and 2 central screws of 10 mm. Then disconnect the LPG hoses using pliers to unlock the clamps on the LPG supply hoses and those of the injectors. With a screwdriver, push the hoses down without pulling them. The GRS 12 injectors cannot be directly removed from the rail: they are secured by two pins and glue, so to remove them, use a thin drill bit to remove the glue from the pin holes, then gently tap with a hammer from the other side to release them and finally extract the injector. Now you can clean the spring and seats with a non-aggressive spray. For reassembly, place the spring back in its seat, reposition the pins, tapping them to secure, and apply hot glue to lock them. Now reassemble the rail, reconnect the LPG hoses and electrical connectors, and secure the rail with the screws (tighten moderately).

Posted on 1 March 2026 by ScegliAuto

Video tutorial

Related tutorials

Dacia Sandero (2021-2026 / MK 3) The Dacia Sandero Stepway has pros and cons that you should know if you are considering purchasing it. Dacia has high maintenance costs, which are ne…
Dacia Sandero (2021-2026 / MK 3) This video shows how to change the LPG filter (gas phase) on a Dacia Sandero MK3, which was replaced at 18,640 miles, as recommended by the manufactu…
Dacia Sandero (2012-2020 / B8) In this video, we will see how to replace the air vent in the Dacia Sandero II LPG: the YouTuber replaces only one, but the procedure is the same for…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos