Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Wishbone of a Fiat Panda

Model: Fiat Panda 141, MK 1 - Years 1980-2003
Part: Control arm

How do you remove the front wishbone of a Fiat Panda? First, place the car on a column lift (jack) and loosen the wheel nuts with a socket wrench, then lift the vehicle to your preferred height and remove the wheel. Use a socket wrench to unscrew the lower securing bolt of the wishbone and the bolt mounted under the wheel hub; unscrew the bolts on the upper part of the arm (as shown in the video). Remove the wishbone from the bolt seats with the help of a pry bar. After comparing the replacement part with the new one (if suitable), install it. Now begin fitting the new part: insert the wishbone into both ends of the guides and start tightening all the bolts into the threads.

Updated on 8 March 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Wiper Blade on a Fiat Panda (169, mk 2)
How to Replace the Wiper Blade on a Fiat Panda (169, mk 2)
Fiat Panda (2003-2012 / 169, MK 2) In this tutorial, see how to replace the wiper blade on a Fiat Panda (169, mk 2) by following these simple steps. The Fiat Panda uses a rear wiper bl…
How to replace the rear wiper on a Fiat Panda?
How to replace the rear wiper on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) To replace the rear wiper on a Fiat Panda, lift the plastic cover at the base of the wiper and loosen the nut underneath using a 10 mm spanner. This …
How to replace the windshield wipers of the Fiat Panda
How to replace the windshield wipers of the Fiat Panda
Fiat Panda (2003-2012 / 169, MK 2) On the second series Fiat Panda, replacing the wipers is done without particular issues. First, work is done on the front wipers: lift the arm, reach…

Other guides you may be interested in

    Frequently Asked Questions

    • Panda 2012-2026 - How much does a Fiat Panda arm cost? Read answer

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos