|
Do it yourself
| |||
| ||||
How to Convert a Cigarette Lighter to a Dual USB Port
Model: Fiat Stilo
MK 1
- Years 2001-2010
Let's see how to convert a cigarette lighter (in this case, a Fiat Stilo, but the system is valid for all vehicles) into a dual USB socket. You can find the dual USB on AliExpress with code 1005003194817235 for £3.24 (free delivery for orders over £20). Remove the cigarette lighter using a screwdriver on the edges to lift it out and disconnect the connector. There are usually three wires: positive, negative, and neutral. Use a tester to identify the wires. Lift the tabs on the connectors and pull the wires from the old connectors (keep them if you want to reinstall the cigarette lighter in the future). The USB socket already has a built-in 12V/5V converter. Connect the positive wire to the positive terminal of the socket, and do the same with the negative wire (be careful with the polarity: reversing it can cause damage). Insulate the connections with electrical tape. Test with a phone to check if it charges, insert the new socket into the original space, and you're done!
Posted on 19 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Fiat Stilo
(2001-2010 /
MK 1)
To reset the air conditioning system of the Fiat Stilo, you will need to press and hold down the two buttons located on the sides of the control pane…
Fiat Stilo
(2001-2010 /
MK 1)
Replacing the fuel filter on a Fiat Stilo is an extremely simple and quick operation. First, wait for the engine to be completely cold. Open the bonn…
Fiat Stilo
(2001-2010 /
MK 1)
In this guide, you will learn how to remove and replace the gear lever knob on a Fiat Stilo in simple steps. First, get inside the vehicle and rotate…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.062
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |