Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Rear Suspension on Fiat Bravo 2

Model: Fiat Bravo Bravo 2 - Years 2007-2014
Part: Suspension system

In today's tutorial, you will learn how to remove and replace the rear shock absorbers on a second series Fiat Bravo by following these simple steps. First, open the boot and remove the cover to access the top of the suspension; then, undo the top bolt. Next, lift the vehicle and remove the wheel; disconnect the suspension from the arm by undoing the fixing pin, as shown in the video. Finally, remove the old suspension and replace it with the new one, following the video to the end!

Updated on 2 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Suspension of the Fiat Bravo
How to Replace the Front Suspension of the Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) Today, follow these instructions to remove and replace the front suspension of the Fiat Bravo. First, open the bonnet and start by loosening the nut …
Replacing the Rear Brake Pads on a Fiat Bravo
Replacing the Rear Brake Pads on a Fiat Bravo
Fiat Bravo (2007-2014 / Bravo 2) In this video, you will learn how to remove and replace the rear brake pads on a Fiat Bravo. First, lift the car with a jack and remove the rear whee…
How to replace the rear brake pads on the Fiat Bravo?
How to replace the rear brake pads on the Fiat Bravo?
Fiat Bravo (2007-2014 / Bravo 2) In this tutorial, you will see how to replace the rear brake pads on the Fiat Bravo. First, open the bonnet and unscrew the cap of the brake fluid re…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos