Do it yourself
| ||||
|
Fiat Punto - Video tutorial
Model: Fiat Punto
Punto EVO, Grandepunto , MK 3, 199
- Years 2005-2018 Before starting, it will be necessary to open the front hood of our Fiat Punto. I highly recommend doing this with a cold engine. So let's start by unscrewing and removing the cap of the expansion tank that contains the coolant inside. Once this is done, we will have to unscrew and remove the plastic bleed nut, using a thirteen millimeter wrench. At this point, we will have to proceed by placing a container under the tap located in the lower part of the radiator, and then unscrew the tap nut itself. By doing so, all the coolant will drain out. When all the coolant has run out, we will have to turn off the tap. Subsequently we will have to top up through the expansion tank, and then close the bleed screw, and the replacement of the coolant will be finished.
Posted on 6 January 2024 by ScegliAuto
How to replace the coolant on a Fiat Punto
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Before we can start, we will have to go and open the front hood of our Fiat Punto. I highly recommend doing this with a cold engine. So let's start b
How to change the thermostat on the Fiat Grande Punto 1.4
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Let's find out in this video the main instructions to remove and replace the coolant thermostat on the petrol Fiat Grande Punto 1.4. First we open th
How to replace the coolant in the Fiat Grande Punto?
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) In this tutorial we can see how to replace the coolant in the Fiat Grande Punto, a very simple operation to carry out periodically. Before proceeding Other guides that may interest you |
Frequently Asked QuestionsFiat Ducato 2.8 JTD gearbox oil replacementLet's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.038
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |