Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Radiator Expansion Tank in a Fiat Punto

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Radiator

In this video tutorial, see how to replace the radiator expansion tank in a Fiat Punto by following some simple steps: first, purchase a new expansion tank for the coolant from an authorised car parts dealer, along with Paraflu coolant for the radiator. Lift the bonnet and secure it with the prop rod. There are two hoses connected to the tank, one at the bottom and the other at the top, and the tank is held in place by two 10 mm nuts. Use a crosshead screwdriver to loosen the clip holding the upper hose and then disconnect the hose, being careful of any escaping fluid. Unscrew the two 10 mm nuts with a socket wrench. Loosen the clip on the lower hose and lift the tank, disconnecting it from the lower hose (place a container to catch any escaping fluid). Install the new tank in place and connect the two hoses (upper and lower), tightening their respective clips; screw in the two 10 mm nuts; fill the tank with Paraflu coolant (up to a mark just below the upper line).

Updated on 12 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Today we will discover the process of how to replace the coolant in a Fiat Punto. First, we open the hood of our car and begin by disconnecting the t…
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Before starting, exit the cabin of your Fiat Punto and lift the front end using a ramp or jack. Begin by loosening the tensioner that holds the auxil…
Fiat Punto (2005-2018 / MK 3, Punto EVO, 199, Grandepunto ) Replacing the timing belt on a car is a delicate task that is recommended to be performed by experienced personnel. Below are the general operations …

    Frequently Asked Questions

    • Punto 2005-2018 - Where do you put the coolant in the Fiat Punto? Read answer
    • Punto 2005-2018 - Where is the Fiat Grande Punto radiator fluid reservoir located? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos