Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Dismantling the Half Shaft on a Fiat 500

Model: Fiat 500 312 - Years 2007-2021
Part: Axle shaft

In this video tutorial, you will see how to dismantle the half shaft of a Fiat 500. First, lift the vehicle and remove the front wheel: then, remove the central hub bolt and take off the braking system by unscrewing the two screws located behind. At this point, you have access to the half shaft, which you will pull out, as shown in the video; now, refit the new one, lubricating the rotating and splined parts of the half shaft and inserting it into its seat. Finally, reassemble the hub and the braking system, following the video to the end!

Updated on 12 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the CV Joint Boot on the Fiat 500
Replacing the CV Joint Boot on the Fiat 500
Fiat 500 (2007-2021 / 312) In this video tutorial, you will learn how to remove and replace the CV joint boot on the Fiat 500, following the instructions below. First, lift the…
How to Replace the CV Boot on a Classic Fiat 500
How to Replace the CV Boot on a Classic Fiat 500
Fiat 500 (1957-1975 / Epoca) To replace the CV boot on a classic Fiat 500, lift the car using a jack or axle stands so that the corresponding wheel is not in contact with the gro…
Replacing the Clutch on a Fiat 500 1.2
Replacing the Clutch on a Fiat 500 1.2
Fiat 500 (2007-2021 / 312) Today, you will learn the main steps to remove and replace the clutch assembly on a Fiat 500. First, lift the vehicle and remove the front wheels; th…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos