Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Door Panel of the Fiat 500

Model: Fiat 500 312 - Years 2007-2021
Part: Car door

To remove the door panel on the Fiat 500, follow these steps: locate and remove the plastic cover on the handle and the cover on the glove compartment. Using an Allen key, remove the two screws above the glove compartment and the screw on the handle support. Then, lift and pull the door panel from the top to release all the clips around the perimeter. At this point, gently pull the door panel away and be careful to disconnect the cable from the handle at the back. Finally, you can remove the entire panel.

Updated on 15 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Door Panel of a Fiat 500
How to Remove the Door Panel of a Fiat 500
Fiat 500 (2007-2021 / 312) Before you start, open the door of your Fiat 500. Begin by prising off and removing the frame of the internal door handle. Next, remove the inserts f…
How to Remove the Door Handle from a Fiat 500
How to Remove the Door Handle from a Fiat 500
Fiat 500 (2007-2021 / 312) How do you remove the handle from a Fiat 500? To access the handle, you need to remove the door panel. Unscrew the securing screws in the fixed handl…
How to Remove the Rear Door Panel on a Fiat 500X
How to Remove the Rear Door Panel on a Fiat 500X
Fiat 500 (2014-2022 / 500 X) Before you can begin, open the rear door of your Fiat 500X. Start by prying off and removing the cover located above the door panel. Next, unclip and…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos