Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Headlamp of the Fiat 500

Model: Fiat 500 312 - Years 2007-2022
Part: Headlight

In today's tutorial, you will learn how to remove and replace the front headlamp of the Fiat 500 by following the instructions below. First, open the bonnet of your car and start by removing the plastic clips located above the bumper; then, unscrew the fixing screws found on both sides of the front wheel arches, as shown in the video. At this point, detach the bumper from the sides and unscrew the fixing screws of the front headlamp, disconnecting the electrical connector of the bulb; all that remains is to install the new headlamp unit!

Updated on 4 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlamp Bulb on a Fiat 500?
How to Replace the Front Headlamp Bulb on a Fiat 500?
Fiat 500 (2007-2022 / ) To replace the front headlamp bulb on a Fiat 500, open the bonnet to access the screws securing the headlamp from the top. You may also need to detac…
Replacing Headlamp Bulb on Fiat 500
Replacing Headlamp Bulb on Fiat 500
Fiat 500 (2007-2024 / 312) Are the bulbs in the headlamp of your Fiat 500 blown? Here's how to change them. Open the front bonnet by pulling the lever located at the bottom rig…
How to Replace the Front Headlamp Bulb on a Fiat 500
How to Replace the Front Headlamp Bulb on a Fiat 500
Fiat 500 (2007-2022 / 312) To replace the front headlamp bulb on a Fiat 500, open the bonnet to access the components inside the engine bay. Specifically, detach the circular c…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos