Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. 500
    4. : Where are the lambda sensors located in the Fiat 500?

Fiat 500 - Video tutorial

Model: Fiat 500 312 - Years 2007-2022
Part: Lambda sensor
Operation: Where are the lambda sensors located in the Fiat 500?

In this video we can see where the two lambda probes are located in the Fiat 500, very important elements for the correct functioning of the engine and the rather simple replacement. As shown, the first probe is located inside the engine compartment and is positioned right on the exhaust manifold, in the upper area. The second probe is instead located below the vehicle, in the initial part of the exhaust pipe. Before disassembling them, make sure that the engine is completely cold and, in case we have to go under the vehicle, we take all the necessary safety measures.


Posted on 26 October 2022 by ScegliAuto

    Frequently Asked Questions

    • 500 2007-2022 - How to recognize if the lambda probe of the Fiat 500 is malfunctioning? Read Answer
    • 500 2014-2022 - What is the price of the lambda probe on the Fiat 500x? Read Answer
    • 500 2014-2022 - What problems does the lambda probe on the Fiat 500X have? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos