Do it yourself
| ||||
|
Fiat Panda - Video tutorial
Model: Fiat Panda
MK 3, 319
- Years 2012-2023 In this video tutorial we can see how it is possible to install the spacer on the steering wheel in a latest series Fiat Panda: the first thing to do is to lift the bonnet and secure it with the special rod and disconnect the battery. Get on board the car, driver's seat and insert a flat-tip screwdriver into the holes in the rear part of the steering wheel to be able to disconnect the airbag (you have to unhook the clip inside the holes), to do this job you need to arm yourself with a lot patience. Once the clips are released, the whole airbag unit will come out, at this point you have to disconnect the wires that are connected (horn and airbag). Once the airbag is pulled out, inside the steering wheel is a red and black steering wheel control connector, it has a tab, find it and pull it, and the connector will come off. Now you have to unscrew the central nut and then pull the steering wheel away, gently sliding the cables. Then take the female part in aluminum and pass the cables through the hole above and insert the spacer in the column. Retighten the central nut at 60 Nm (with dynamotrix); screw the steel part of the spacer to the corresponding aluminum part, using the screws included in the KIT (tighten to a torque of 8-10 Nm). Now reassemble everything by working backwards.
Posted on 31 October 2022 by ScegliAuto
Other guides that may interest you
|
How to reset the tire pressure warning light on Dacia Sandero?Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.050
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |