Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you remove the gearbox of the Fiat 500?

Model: Fiat 500 Epoca - Years 1957-1975
Part: Transmission

To be able to remove the gearbox of the Fiat 500 you have to go and open the tailgate, since in this car the engine is positioned in the rear part. Once the tailgate has been opened, it will be necessary to start loosening the bolts that secure the gearbox to the side of the engine: then it will be possible to access the lower part of the car, in order to loosen the additional screws that secure the box. and disconnecting the appropriate connectors. In this way it will be possible to completely remove the old gearbox, replacing it with a new one.

Posted on 1 November 2022 by ScegliAuto

Video tutorial

Related tutorials

How to reset and calibrate the automatic gearbox of the Fiat 500
How to reset and calibrate the automatic gearbox of the Fiat 500
Fiat 500 (2007-2024 / 312) Below we will see the steps that will allow us to reset and calibrate the automatic transmission of the Fiat 500. First of all, we get on board the v…
How to remove the gearbox on the Fiat 500
How to remove the gearbox on the Fiat 500
Fiat 500 (2007-2021 / 312) In today's video tutorial we will see how to disassemble and replace the gearbox and clutch on the Fiat 500 1.2, following the instructions below. Fi…
How to change the gearbox oil on the Fiat 500?
How to change the gearbox oil on the Fiat 500?
Fiat 500 (2007-2021 / ) To be able to change the gearbox oil of the Fiat 500 you have to go and lift the car by means of a bridge, so that you can access the components of t…

How to Change the Diesel Filter on a Renault Captur 1.5 dCi

The diesel filter on the Renault Captur is always of the immersion type, but instead of being located at the top of the engine bay, it is positioned lower, inside the front right wheel arch (passenger side), practically under the headlamp. To replace it, it is advisable to lift the vehicle, remove the front right wheel and the corresponding inner lining to access the filter location. Unscrew the fastening nuts of the support clamp to extract it from its housing and disconnect the connector and pipes. At this point, unscrew the fixing screws of the cap, remove the old filter and insert the new one, also replacing the O-ring seals, and then reverse the steps for installation. Before starting the engine, turn the ignition on and off several times to allow the filter to fill.

Watch the video!


by ScegliAuto

More videos