Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the key shell of the Fiat Ducato - Citroen Relay

Model: Fiat Ducato X290 - Years 2014-2024
Part: Key

Today's guide will show us how to disassemble and replace the key shell of the Fiat Ducato, but also of the Citroen Relay. First we pick up our remote control and start removing the plastic back cover; then we unscrew the screw that we find on the key slot, using a slotted screwdriver, as shown in the video. At this point, remove the physical key and open the remote control, removing the electronic board; let's transfer everything to the new key shell, assembling the remote again, following the video tutorial to the end!

Posted on 16 February 2023 by ScegliAuto

This video is currently unavailable

Related tutorials

Open rear doors Citroen Relay - Fiat Ducato
Open rear doors Citroen Relay - Fiat Ducato
Fiat Ducato (2014-2024 / X290) .. see in this guide how to open the rear doors of a Citroen Relay or a Fiat Ducato, as similar models. To open the rear door, the lock must first be unlocked.. …
How do you replace the battery of a Fiat Ducato Boxer Relay key?
How do you replace the battery of a Fiat Ducato Boxer Relay key?
Fiat Ducato (1993-2016 / MK 2) This operation should not be too difficult and you can do it independently. You just need a flathead screwdriver, leverage the key slot to open the s…
How does the Fiat Ducato radiator fan work?
How does the Fiat Ducato radiator fan work?
Fiat Ducato (1993-2016 / MK 2) The radiator fan of the Fiat Ducato is activated whenever the engine temperature is too high and therefore the fan must start to lower it. The operat…

How to Replace the Lift Supports on a Porsche 911

How to remove and replace the lift supports for the hood on a Porsche 911? Let's see how to replace them in this video: Lift the hood and secure it. Use a screwdriver or metal lever to detach the clips that hold the lift support at both ends (or unscrew the mounting pins). Install the new part onto the sheet metal of the front trunk, securing the lift support with the clips/pins. Proceed in the same manner for the removal/installation of the opposite lift support. Finally, test the gas springs installed earlier.

Watch the video!


by ScegliAuto

More videos