Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Oil Filter on the Fiat 500L 1.3 Multijet

Model: Fiat 500 - Years 2012-2021
Part: Oil filter

As shown in the video, to change the oil filter in your Fiat 500 1.3 Multijet, you must first choose the correct filter. There are two types available: UV and Fluxx. To determine which filter is suitable for your vehicle, check the oil filler cap. If it is diagonal, you will need a UV filter; if it is horizontal, you will need the other one. Drain all the oil by unscrewing the single screw located underneath the car. To replace the oil filter, you will need to remove the three screws holding the oil filter cover in place. Remove the filter and replace it with the new one. Refit the cover and reverse all the steps.

Updated on 28 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Glow Plugs on a Fiat 500L 1.3 Multijet
Replacing the Glow Plugs on a Fiat 500L 1.3 Multijet
Fiat 500 (2012-2023 / 500 L) In this brief guide, find the instructions to remove and replace the glow plugs on the Fiat 500L with a 1.3 Multijet engine. First, open the bonnet o…
Changing Engine Oil and Oil Filter on Fiat 500L 1300 MultiJet
Changing Engine Oil and Oil Filter on Fiat 500L 1300 MultiJet
Fiat 500 (2012-2023 / 500 L) With the engine off, lift the bonnet and unscrew the three 10 mm bolts securing the engine cover. At this point, you will see the engine oil filter, …
Engine Oil and Oil Filter Replacement on a Fiat 500 1.3 MultiJet
Engine Oil and Oil Filter Replacement on a Fiat 500 1.3 MultiJet
Fiat 500 (2007-2021 / 312) In today's tutorial video, you will see step-by-step instructions for performing the routine maintenance oil change on a Fiat 500 1.3 MultiJet. First…

    Frequently Asked Questions

    • 500 2012-2023 - Where is the Fiat 500 L oil filter located? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos