Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the CV joint on a Fiat Panda?

Model: Fiat Panda 141, MK 1 - Years 1980-2003
Part: Checks and maintenance

To replace the CV joint on a Fiat Panda, lift the car to completely remove the front wheel corresponding to the joint to be replaced. Once the wheel is removed, you will have access to the components at the rear: the driveshaft must be detached from the hub by extracting it completely. After the driveshaft has been removed, you can disconnect the CV joint from it, replacing it with a new part and reassembling all previously removed components.

Updated on 18 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the CV Joint on a Fiat Panda
Replacing the CV Joint on a Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) If you need to carry out extraordinary maintenance on your vehicle, specifically replacing the CV joint, follow the instructions below and refer to t…
How to Replace the CV Joint Boot on the Old Fiat Panda
How to Replace the CV Joint Boot on the Old Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) If you hear a noise coming from the wheel, especially when steering, it is likely that the CV joint of the driveshaft is operating without grease due…
Removing the Front Driveshaft Boot on Fiat Panda 4x4
Removing the Front Driveshaft Boot on Fiat Panda 4x4
Fiat Panda (1980-2003 / 141, MK 1) See how to replace the boot on the driveshaft of the legendary Fiat Panda 4x4. First, remove the brake caliper by taking out the bolt that holds it i…

    Frequently Asked Questions

    • Panda 2012-2026 - Where is the outside temperature sensor on the Fiat Panda located? Read answer
    • Panda 2003-2012 - What causes the power steering problem on the Fiat Panda? Read answer
    • Panda 2003-2012 - How to adjust the headlights in the Fiat Panda? Read answer
    • Panda 2012-2021 - What is the tightening torque of the rear wheel hub nut of the Fiat Panda? Read answer
    • Panda 2012-2021 - How many liters of fuel does the Fiat Panda have in reserve? Read answer
    • Panda 2003-2012 - Where is the oil pressure sensor located in the Fiat Panda? Read answer
    • Panda 2012-2026 - How to fold back seats in the Fiat Panda? Read answer
    • Panda 2012-2026 - How many km can the Fiat Panda travel in reserve? Read answer

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos