Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the CV Joint Boot on the Old Fiat Panda

Model: Fiat Panda 141, MK 1 - Years 1980-2003
Part: CV boot

If you hear a noise coming from the wheel, especially when steering, it is likely that the CV joint of the driveshaft is operating without grease due to a broken boot: you can replace the boot from the wheel side without having to remove the joint from the driveshaft, simply using a special plastic cone that acts as a fitting; however, you must first remove the driveshaft from the hub and, before lifting the vehicle, loosen the nut at the centre of the wheel; then lift the vehicle, remove the wheel, and disconnect the hub from the shock absorber and the arm ball joint; once the driveshaft is removed from the hub, remove the retaining clips of the boot and cut it off; at this point, generously lubricate the cone and insert the boot inside out, sliding it down to the base before fitting it onto the CV joint; apply grease to the joint and secure the boot with the appropriate clips, then proceed in reverse for reassembly.

Updated on 22 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the CV Boot on Fiat Panda
How to Remove the CV Boot on Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) Let’s see how to remove the boot from the joint on a Fiat Panda. After positioning your car on a column lift: raise it to a comfortable height to wor…
How to replace the CV joint on a Fiat Panda?
How to replace the CV joint on a Fiat Panda?
Fiat Panda (1980-2003 / 141, MK 1) To replace the CV joint on a Fiat Panda, lift the car to completely remove the front wheel corresponding to the joint to be replaced. Once the wheel …
Replacing the CV Joint on a Fiat Panda
Replacing the CV Joint on a Fiat Panda
Fiat Panda (1980-2003 / 141, MK 1) If you need to carry out extraordinary maintenance on your vehicle, specifically replacing the CV joint, follow the instructions below and refer to t…

How to Replace the Diesel Filter of the Peugeot 3008 1.5 BlueHDI

Briefly, we will see the main instructions for dismantling and replacing the diesel filter of the Peugeot 3008 1.5 BlueHDI. First, locate the diesel filter under the vehicle, so it will be necessary to lift it; then disconnect the electrical connector and the fuel lines from the filter, unscrewing the side screws to remove the cartridge, as shown in the video. At this point, replace the diesel filter with the new one, as well as with the original one; then reconnect the pipes and the electrical connector, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos