Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Front Driveshaft Boot on Fiat Panda 4x4

Model: Fiat Panda MK 1, 141 - Years: 1980, 1981, 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991
Part: Axle shaft

See other generations:
Video tutorial

See how to replace the boot on the driveshaft of the legendary Fiat Panda 4x4. First, remove the brake caliper by taking out the bolt that holds it in place; now also remove the disc and detach the suspension from the support. Remove the four screws holding the hub for easy access.

Now, unscrew the three support screws of the boot to be replaced on the differential using a 10mm socket: this will allow you to finally extract the entire CV joint from which you can then remove the boot.


Updated on 17 March 2026 by ScegliAuto


Related tutorials

How to Replace the CV Boot on a Fiat Panda?
How to Replace the CV Boot on a Fiat Panda?
Fiat Panda (2003-2012 / 169, MK 2) To replace the CV boot on a Fiat Panda, first loosen the bolts securing the wheel corresponding to the boot that needs replacing. Once the wheel has …
Replacing Drive Shaft Boots
Replacing Drive Shaft Boots
Fiat Panda (1980-2003 / MK 1, 141) The boot itself costs only a few pounds, but if it wears out, it risks leaking gearbox oil, causing seizing within a few hours. Unfortunately, the o…
Replacing the Gear Gaiter on the Fiat Panda 4x4
Replacing the Gear Gaiter on the Fiat Panda 4x4
Fiat Panda (1980-2003 / MK 1, 141) In today's video tutorial, we will cover the main instructions for dismantling and replacing the gear gaiter on the Fiat Panda 4x4. First, lift the v…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos