Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Drum Brake Shoes on a Fiat Punto

Model: Fiat Punto MK 2, 188 - Years 1999-2011
Part: Brake drums and shoes

Let's see how to change the drum brake shoes on a Fiat Punto. Lift the car and remove the wheel, ensuring the handbrake is released. Using a large screwdriver, remove the protective cap from the central nut and unscrew it with a 32 mm socket, allowing you to also remove the drum cover. Now, lift the retaining tabs of the shoes to remove them. Disconnect the handbrake lever support and pull it out. Clean the surfaces of dust with brake cleaner spray. When changing the shoes, it is advisable to also replace the brake cylinder, so disconnect the control pipe and unscrew the two screws securing it to the plate, install the new cylinder and reconnect the pipe. Clean again with the appropriate spray. Apply some copper grease to the contact surfaces of the shoes and install the new brake shoes, which can be found in pre-assembled kits. Refit the retaining clips for the shoes, reconnect the handbrake lever, clean with spray, and use sandpaper inside the drum before refitting it. Tighten the central nut with a torque wrench, replace its cover, and finally bleed the brake fluid. Repeat the process on the other wheel.

Updated on 1 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Fiat Punto (1999-2011 / MK 2, 188) Below are the instructions for removing and replacing the rear brake shoes on a Fiat Punto. First, lift the vehicle at the rear and start by removing…
Fiat Punto (1993-1999 / MK 1, 176) As we can see in the video, the drum brake is a hydraulic activation brake: when the brake pedal is pressed, the brake fluid puts pressure on a hydra…
Fiat Punto (1999-2011 / MK 2, 188) To check the wear of the rear brake shoes, you must remove the drum. First, loosen the wheel fixing nuts of the rear wheel before lifting the vehicle…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos