Do it yourself
Frequently asked questions about cars and motorcycles

How to disassemble the ABS module on a Ford Fiesta or Focus

Model: Ford Fiesta MK 7, MK VII, Fiesta 7 - Years 2017-2023
Part: Checks and maintenance

In this video, we see how to disassemble the ABS module on a Ford vehicle: the module is located right under the windshield wiper, and to reach it we will use a key with an extension, and it is the brain of the ABS. To perform this operation, it is not necessary to bleed the brakes; we will need to disconnect the electrical connector and remove the fixing bolts indicated by the youtuber (one of them is a bit difficult to reach, being hidden behind the module itself). Once the screws are removed, we can extract the module, being careful not to damage the connector and not to lose the gasket, otherwise we will not be able to reassemble it later.

Posted on 3 September 2024 by ScegliAuto

Video tutorial

Related tutorials

Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) Replacing the ABS sensor on a Ford Fiesta? Let's see how to disassemble the part. Lift the car with a jack, unscrew the wheel bolts with a socket spa…
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) In this video, you can see where the transmission control module is located on the Ford Fiesta and how to proceed if you need to remove it. As shown,…
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) In this video, see how to reinitialize the Sync module on a Ford Fiesta (the procedure is the same for all Ford vehicles). Tap the phone button until…

Other guides you may be interested in

    Frequently Asked Questions

    • Fiesta 2008-2017 - What problems does the Ford Fiesta 1.4 TDCi have when accelerating? Read answer
    • Fiesta 2008-2017 - What does MCA mean on a Ford Fiesta? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos