Do it yourself
Frequently asked questions about cars and motorcycles

How to Diagnose a TPMS Issue on a Ford Fiesta MK 7.5

Model: Ford Fiesta MK 7, MK VII, Fiesta 7 - Years 2017-2023
Part:

This is a complete guide to diagnosing a TPMS (Tyre Pressure Monitoring System) issue on a Ford Fiesta MK 7.5. If the warning light is on but the tyre pressures are correct, the issue is likely a faulty TPMS sensor or a dead battery. Prepare the vehicle for 'sensor programming' mode. With the engine off, press and release the brake pedal; turn the ignition on and then off. Repeat this sequence two more times, and finally leave the ignition on: press and release the brake pedal again. Turn the ignition off and on one last time; the vehicle will emit a beep and the TPMS light on the dashboard will flash for a few seconds. The vehicle is now in relearn mode and awaits signals from each sensor, starting with the front left tyre. Now you need a programming tool, bring it close to the tyre valve (where the sensor is located) and if it is functioning, the vehicle will beep. Repeat this for the front right, rear right, and rear left. If any sensor does not respond, that sensor is faulty or dead. Replacement can only be done by a tyre specialist as it requires special equipment.

Posted on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Ford Fiesta (2017-2023 / MK 7, MK VII, Fiesta 7) Today's information will allow us to reset the tire pressure warning on the Ford Fiesta; before resetting the TPMS sensors, it is necessary for all f…
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) The TPMS tire pressure warning light comes on in a Ford Fiesta when the tire pressure needs to be adjusted. First, we adjust the pressure of each tir…
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) Today's main instructions will allow us to reset the tire pressure warning light on the Ford Fiesta; before resetting the TPMS sensors, all four tire…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos