Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Parking Sensors

Model: Ford C Max MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010
Part: Parking sensors

See other generations:
Video tutorial

Apply a strip of masking tape on the rear bumper where the parking sensors will be installed: it is recommended to use the unpainted lower plastic strip. Mark the points where the sensor housing holes will be drilled, positioning them equidistantly.

Then drill the holes with an appropriately sized hole saw. Secure the sensors and route the wiring through the rear bonnet to access the reverse light signal (following the attached wiring diagram) and position the display inside the cabin.


Updated on 4 February 2026 by ScegliAuto


Related tutorials

Fitting a Window Deflector
Fitting a Window Deflector
Ford C Max (2010-2019 / MK 2) Fitting a small deflector to the window makes driving more comfortable by allowing better air circulation and avoiding turbulence and annoying noise.…
How to Reset the Tyre Pressure Sensor Light on a Ford C-Max?
How to Reset the Tyre Pressure Sensor Light on a Ford C-Max?
Ford C Max (2010-2019 / MK 2) The warning from the tyre pressure sensors about abnormal inflation pressure activates an error message and the warning light. After confirming the i…
How to Program the TPMS Sensors on a Ford C Max
How to Program the TPMS Sensors on a Ford C Max
Ford C Max (2010-2019 / MK 2) Today, you will learn how to program the new sensors for tyre pressure monitoring on a Ford C Max vehicle. Once the new sensors have been removed and…

How to Open the Hood of the BMW X3

Today, you will learn how to open and close the hood of the BMW X3. To perform this simple operation, lift the hood release lever located next to the door seal on the driver’s side. After pulling the lever, you will notice that the hood will lift slightly. Position yourself in front of the hood and lift it after moving the internal lever from left to right. To keep the hood secure during maintenance, use the side support rod. To close the hood, simply let it fall back into place.

Watch the video!


by ScegliAuto

More videos