Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Parking Sensors on a Ford Fusion?

Model: Ford Fusion North America MK 1 - Years 2006-2012
Part: Parking sensors

In this tutorial, you will see how to replace the rear parking sensors on a Ford Fusion, a very simple and quick operation. First, ensure the key is not in the ignition, then lift the rear side of the vehicle, taking the necessary safety measures. Go underneath the bumper and locate the first sensor. Next, unlock the retaining clips, separate it from the bumper, and disconnect the power connector. At this point, simply connect the replacement, reinstall it in its place, and repeat the process for the opposite sensor.

Updated on 4 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to put the parking brake in service mode on the Ford Fusion
How to put the parking brake in service mode on the Ford Fusion
Ford Fusion North America (2013-2020 / MK 2) In this guide we will see the instructions that will allow us to put the parking brake in service mode, necessary to replace the rear brake pads of t…
Where is the fuse box of the Ford Fusion located?
Where is the fuse box of the Ford Fusion located?
Ford Fusion North America (2006-2012 / MK 1) If you don't know where the fuse box is located inside the cabin of your first-generation Ford Fusion, don't worry because with the following guide y…
Removing the Taillights and Bulbs on a Ford Fusion
Removing the Taillights and Bulbs on a Ford Fusion
Ford Fusion North America (2006-2012 / MK 1) Today, let's go through the instructions to remove and replace the taillight and its bulbs on a Ford Fusion. First, open the trunk lid and start by r…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos