Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Fan Resistor on a Ford Focus

Model: Ford Focus MK 1 - Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004
Part: Blower motor

See other generations:
Video tutorial

Let's look at removing the ventilation fan resistor on a Ford Focus. Use a lever to remove the plastic trim inside the front dashboard (glove compartment), then unscrew the cover where the resistor is located with a screwdriver.

Disconnect the large connector from the resistor, then pull it out of the cabin. Insert a new fan resistor (connect the power connector).

Finally, reassemble the cover trim and the glove compartment (tighten the screws). Check the correct installation of the previously fitted parts and test their proper operation.


Updated on 13 March 2026 by ScegliAuto


Related tutorials

Replacing the Cabin Fan Resistor on a Ford Focus
Replacing the Cabin Fan Resistor on a Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Today's steps will show you how to remove and replace the cabin fan resistor on a Ford Focus. First, get inside the vehicle on the front passenger si…
How to Change the Fan Resistor on a Focus
How to Change the Fan Resistor on a Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Change the climate control fan resistor on a Focus? Open the door and begin removing the plastic cover under the centre tunnel (pedal side). Use a sc…
Removing Cabin Fan Resistor on Ford Focus
Removing Cabin Fan Resistor on Ford Focus
Ford Focus (1998-2004 / MK 1) Removing the cabin fan on a Ford Focus? Remove the glove compartment to access the part to be removed. Take out the glove compartment located in the …

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos