Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to change the fan resistance on Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Interior blower
Operation: How to change the fan resistance on Focus

Changing the climate fan resistance on a Focus? We open the door and begin to remove the plastic protection under the central tunnel (pedal side). Using a screwdriver, unscrew the tightening screws placed above the cover. Once this is done we go to detach the cover and find the resistance. We disconnect the resistance from inside the dedicated compartment. We insert the new fan resistor: we connect the fan. We mount the cover over the fan and screw in the clamping screws. We turn on the vehicle and check the operation of the climate fan.


Posted on 18 December 2023 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - Why is the fan of the Ford Focus not working? Read Answer
    • Focus 2011-2018 - Why is the Ford Focus cabin fan not working? Read Answer
    • Focus 2011-2018 - What to do if the Ford Focus interior fan does not work? Read Answer
    • Focus 2018-2025 - Why is the Ford Focus interior fan not working? Read Answer
    • Focus 2011-2018 - What to do when the Ford Focus interior fan does not work? Read Answer
    • Focus 1998-2004 - Where is the Ford Focus internal fan resistor located? Read Answer
    • Focus 1998-2004 - Where is the interior fan of the Ford Focus? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos