Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Fiesta
    4. : Ford Fiesta ST lambda probe replacement

Ford Fiesta - Video tutorial

Model: Ford Fiesta MK VI, Fiesta 6, MK 6 - Years 2008-2017
Part: Lambda sensor
Operation: Ford Fiesta ST lambda probe replacement

In today's video tutorial we will see the instructions to be able to remove and replace the lambda probe on a Ford Fiesta, in the ST variant. First we go to open the bonnet of our car and we go to remove the plastic protection of the engine; then we disconnect the two battery terminals (positive and negative pole), unscrewing the nuts with a wrench. At this point, unscrew the screws of the intake sleeve clamp and disconnect the electrical connector of the mass / air sensor; remove all the intake duct which extends to the rear of the engine. We thus access the lambda probe, where we will disconnect the electrical connector and unscrew the sensor with a key, as shown in the video!


Posted on 24 March 2024 by ScegliAuto



Ford Fiesta lambda probe replacement
Ford Fiesta (2002-2008 / MK V, Fiesta 5, MK 5) Today we will see how to remove and replace the lambda probe of a second series Ford Fiesta. First of all, we open the bonnet of our car and we go to
Ford Fiesta lambda probe removal
Ford Fiesta (2002-2008 / MK V, Fiesta 5, MK 5) In this video tutorial we will show you how to remove the lambda probe on the Ford Fiesta mk6. First we lift the car with a hydraulic jack and positi
Lambda catalyst sensor replacement on Ford Fiesta
Ford Fiesta (2002-2008 / MK V, Fiesta 5, MK 5) Lift the car from the lower frame and put on two support stands. The lambda probe in question is located between the steering box and the front axle

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos