Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Diesel Filter on a Ford Focus

Model: Ford Focus MK 2, Focus 2 - Years 2004-2011
Part: Diesel fuel filter

Do you want to replace the diesel filter on your Ford Focus? Let’s look at removing the filter. Locate the diesel filter as shown in the video. Disconnect all the hoses leading to the diesel filter and unplug the electrical connector. Unscrew the bolts near the container where the diesel filter is located. Once the filter is removed, take it out of the vehicle (replace it with a new filter). Install the filter into the attached container (reconnect hoses and cables) and tighten the appropriate bolts. Close the bonnet after installation. Remember to connect all hoses to the new filter.

Updated on 3 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Diesel Filter from a Ford Focus
How to Remove the Diesel Filter from a Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) Before you can start, open the bonnet of your Ford Focus. Begin by unclipping and removing the upper engine cover. Next, unscrew and remove the bolts…
How to Replace the Diesel Filter on a Ford Focus
How to Replace the Diesel Filter on a Ford Focus
Ford Focus (2004-2011 / MK 2, Focus 2) How to replace the diesel filter on a Ford Focus? In this video, see the replacement process. Open the car door and pull up the engine compartment re…
How to Replace the Fuel Filter on a Ford Focus 1.5 TDCI
How to Replace the Fuel Filter on a Ford Focus 1.5 TDCI
Ford Focus (2011-2018 / MK 3) This guide briefly explains the steps to remove and replace the fuel filter on a Ford Focus 1.5 TDCI. First, open the engine bonnet and locate the fu…

    Frequently Asked Questions

    • Focus 2004-2011 - How much does it cost to replace the diesel filter on the Ford Focus 1.6 tdci? Read answer

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos