Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Injectors and Copper Washers from the Ford Fiesta 1.4 TDCi

Model: Ford Fiesta Fiesta 5, MK 5, MK V - Years 2002-2008
Part: Fuel injectors

In today's video tutorial, see the main steps to remove the diesel injectors and their copper washers (which often cause leaks) from the Ford Fiesta 1.4 TDCi. First, open the bonnet and start by removing the cylinder head cover; then, undo the injectors to remove them, disconnecting the electrical connector. At this point, use pliers to extract the washer, replacing it with a new one; then install the new injectors on the engine with original parts, following the video tutorial to the end!

Updated on 14 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove Injectors on Ford Fiesta MK6 1.6 TDCI
How to Remove Injectors on Ford Fiesta MK6 1.6 TDCI
Ford Fiesta (2002-2008 / Fiesta 5, MK 5, MK V) In this video tutorial, you will learn how to remove and replace the diesel injectors on the sixth series Ford Fiesta with a 1.6 TDCI engine. First, …
How to Remove the Injectors from the Ford Fiesta 1.4 TDCi
How to Remove the Injectors from the Ford Fiesta 1.4 TDCi
Ford Fiesta (2002-2008 / Fiesta 5, MK 5, MK V) This guide provides the main instructions for removing and replacing the fuel injectors of the Ford Fiesta 1.4 TDCi. First, open the bonnet of your c…
How to Replace the Injectors on a Ford Fiesta 1.6 TDCi
How to Replace the Injectors on a Ford Fiesta 1.6 TDCi
Ford Fiesta (2008-2017 / Fiesta 6, MK 6, MK VI) To replace the injectors on a Ford Fiesta 1.6 TDCi, open the bonnet to access the components at the top of the engine block after removing the plasti…

Other guides you may be interested in

    Frequently Asked Questions

    • Fiesta 2008-2017 - What is the tightening torque of the Ford Fiesta 1.4 TDCi injectors? Read answer

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos