Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Light on the Ford Explorer Sport Trac

Model: Ford Explorer U152, MK 3 - Years 2002-2005
Part: Tail light

Today, you will see in this short video how to remove and replace the rear light on the Ford Explorer Sport Trac in simple steps. Move to the rear of your vehicle and start by opening the load bed; then, remove the side plastic covers, using a socket spanner to loosen all the screws of the light, as illustrated in the video. At this point, gently remove the light by prying on the sides, disconnecting the electrical connector of the bulbs; finally, replace the bulbs if necessary and reassemble everything, applying the reverse procedure!

Updated on 29 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Fuse Box of a Ford Explorer
Ford Explorer (2006-2010 / U251, MK 4) This useful video shows the location of the two fuse boxes in our Ford Explorer, Sport Trac model, produced from 2006 to 2010. As seen in the tutoria…
How to Replace the Rear Wiper on a Ford Explorer
How to Replace the Rear Wiper on a Ford Explorer
Ford Explorer (2006-2010 / U251, MK 4) Today, in this tutorial video, you will learn how to remove and replace the rear wiper on a Ford Explorer in simple and quick steps. First, move to t…
How to Replace the Rear Light Bulb on the Ford Explorer?
How to Replace the Rear Light Bulb on the Ford Explorer?
Ford Explorer (2006-2010 / U251, MK 4) To replace the rear light bulb on the Ford Explorer, open the tailgate of the boot to access the bolts located between the light and the seal. By uns…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos