Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Fiesta
    4. : How to remove the exterior mirror in the Ford Fiesta?

Ford Fiesta - Video tutorial

Model: Ford Fiesta MK 6, Fiesta 6, MK VI - Years 2008-2017
Part: Outside rearview mirror
Operation: How to remove the exterior mirror in the Ford Fiesta?

Removing the exterior rearview mirror, in the Ford Fiesta 6, is very simple, let's see how to proceed in this video. First of all, to access the regulator connector, the interior door panel must be removed. So let's start by disengaging the front part of the opening handle, then unscrew the two screws below it, the screw inside the opening handle and the one inside the small reflector. At this point, we disengage the panel from the door and disconnect the mirror connector. Finally, we disassemble the latter by unscrewing the single bolt with a 13mm wrench.


Posted on 10 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Fiesta 2008-2017 - How to remove the rearview mirror of a Ford Fista VI? Read Answer
    • Fiesta 2008-2017 - How much does it cost to replace the exterior mirror on the Ford Fiesta? Read Answer
    • Fiesta 2008-2017 - How much does the Ford Fiesta VI exterior rear view mirror cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos