Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. GMC
    3. :
  3. Hummer Ev
    4. : How to disassemble and reassemble the sunroof of the GCM Hummer EV

GMC Hummer Ev - Video tutorial

Model: GMC Hummer Ev MK 1 - Years 2022-2024
Operation: How to disassemble and reassemble the sunroof of the GCM Hummer EV

The roof removal operation of the GCM Hummer is extremely simple. The roof is divided into four numbered panels which can be released very easily, just by loosening two levers for each panel with a rotating movement: in this way it is enough to remove the panel from the anchoring support and repeat the operation for the other three panels. These must be placed in the trunk - located in the front part of the car - in the opposite sequence to that in which they are removed, to find them ready to be reassembled. Two practical straps created for this use are included in the trunk, which will hold the panels in place even on the roughest terrain. Now we have to remove the longitudinal bars, in order to be able to enjoy the sunroof to the fullest: under the rear seat we have the kit for carrying out this operation, by removing the four screws that hold the two bars in place. There is a special slot for these four screws, so you can be sure not to lose them. A slot under the seat is also provided for the two bars. To reinstall the roof, you can proceed very easily: in fact, one of the bars has the wording "front", where the other will obviously be the rear one. It will be enough to screw back the screws that we had suitably housed, and reinstall the 4 panels that we had placed so as to be able to start again from number 4. We close the levers relating to each panel and the roof is installed again.


Posted on 4 December 2022 by ScegliAuto

How do you adjust the clutch cable on the Kia Picanto?

To be able to adjust the clutch cable of the Kia Picanto you need to open the hood so that you have access to the components inside the engine compartment: in order to reach the cable you will need to remove some components on the right side, such as the battery and the air filter. Below them you will find the clutch cable, which will have to be adjusted by screwing or loosening the bolt placed at the end of the cable. This will make the pedal harder or softer; after the adjustment, it will be possible to assemble all the components by closing the hood.

Watch the video!


by ScegliAuto

More videos