Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Dismantle the Engine of a Husaberg TE 125?

Model: Husaberg Te 125
Part: Engine

Video tutorial

To dismantle the engine of a Husaberg TE 125, you need to loosen the screws that secure the engine block to its housing so that it can be extracted after disconnecting the pipes and connectors. At this point, you can proceed to loosen the screws that secure the cylinder, allowing it to be removed: the piston inside can then be freed from the connecting rod by removing the ring and pin. This will provide access to the crankshaft, allowing for the replacement of all internal engine components.


Updated on 28 October 2026 by ScegliAuto


Related tutorials

How to Remove the Muffler Belly on a Husaberg TE 125
How to Remove the Muffler Belly on a Husaberg TE 125
Te 125 Before you start, position your Husaberg TE 125 on its side stand. This operation must be performed with the engine and exhaust cold. Begin by unscre…
Engine Oil Change on Husaberg TE 125 2T
Engine Oil Change on Husaberg TE 125 2T
Te 125 In this video, learn how to change the engine oil on a Husaberg TE 125 two-stroke by following these simple steps. First, warm up the engine for a fe…
How to Polish the Clutch Cover of the Husaberg TE 125
How to Polish the Clutch Cover of the Husaberg TE 125
Te 125 This guide provides instructions to disassemble and polish the small clutch cover of the Husaberg TE 125 enduro bike. First, place the bike on a stan…

How to Replace the Air Filter on the Kawasaki Ninja 1000 SX?

In this tutorial, you will see how to replace the air filter on the Kawasaki Ninja 1000 SX, a very simple and quick operation. First, remove the seat, then take off both side panels by unscrewing the respective screws and unscrew the two bolts located at the front of the fuel tank. Next, lift the tank, support it with a rope if necessary, and remove the top cover of the airbox. At this point, extract the old filter, clean the inside of the housing from any dirt residue, and fit the new part by reversing the procedure.

Watch the video!


by ScegliAuto

More videos