Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Model: Husaberg Te 125
Part: Engine oil

After placing the bike on a surface and placing it in a stable and safe position so that you can work on it safely, we proceed to remove the engine protection, from water and mud, positioned in the lower part of the engine itself. To do this, just turn the screw that locks it in place and disengage it from its position, as shown in the video images. Now, unscrew the cap of the opening relating to the engine oil and, then, after having positioned a pan under the engine block (in correspondence with the hole to empty the engine of old oil), unscrew the nut, which we find in the low / external of the engine block, which covers that hole itself (as we can see in the images). Let all the old engine oil drain out and screw the nut back on. At this point, unscrew, using the appropriate key, the magnet and, after having cleaned it, put it back in position. Finally, we can pour the new oil into the appropriate mouth. And that's it!


Posted on 19 November 2023 by ScegliAuto

This video is currently unavailable


Engine oil change on Husaberg TE 125 2T
Te 125 Let's see in this video how to change the engine oil on a Husaberg TE 125 two-stroke, following these simple steps. First of all, let the engine warm
How to remove the muffler belly of a Husaberg TE 125
Te 125 Before we can start, we will have to place our Husaberg TE 125 on the side stand. This operation must only be carried out with the engine and muffler
How do you disassemble the engine of the Husaberg TE 125?
Te 125 In order to disassemble the engine of the Husaberg TE 125, you need to loosen the screws that fix the engine block to its housing, so that the latter

How to replace the motor oil in the Yamaha Tracer 900?

In this tutorial we can see how to replace the engine oil in the Yamaha Tracer 900, an extremely simple and quick operation. First of all, we wait for the engine to be cold enough, then we place a container under the motorcycle, locate the drain hole bolt and unscrew it using a 17mm socket wrench. We then let all the oil in the system drain out, unscrew the old filter, and tighten both the replacement and the bolt. At this point, all that's left to do is to pour in the required amount of oil through the designated top hole.

Watch the video!


by ScegliAuto

More videos