Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I20
    4. : Timing belt

Hyundai I20 - Timing belt

Hyundai I20 (2008-2014 / PB, MK 1)
Guide on how to change the timing chain on the Hyundai I20 1.2
In this short guide we will discover the main steps on how to remove and replace the timing chain on Hyundai I20 first series, with 1.2 engine; in general the …read all…
Posted on 5 June 2022 by ScegliAuto
Hyundai I20 (2008-2014 / PB, MK 1)
Hyundai I20 1.4 CRDI timing chain replacement guide
Let's see in this guide how to disassemble and replace the timing chain of the Hyundai I20 1.4 CRDI, following the instructions below. In the case in question, …read all…
Posted on 20 April 2024 by ScegliAuto
Hyundai I20 (2008-2014 / PB, MK 1)
How to replace the timing chain on a Hyundai I20
Before we can start, we will have to go and open the front hood of our Hyundai I20. So let's start by disassembling and removing the injectors and the upper …read all…
Posted on 5 February 2024 by ScegliAuto
Airbags (1) Battery (2) Spark plugs (2) Key (4) Timing belt (3) -board computer (1) Checks and maintenance (4) Cabin air filter (2) Light bulb (1) Rear light bulb (1) Handle (1) Starter motor (1) Door panel (1) Fuel pump (1) Instrument cluster (2) Fuse box (1) Outside rearview mirror (1) Steering wheel (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos