Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I20
    4. : Removing the rear bumper Hyundai i20

Hyundai I20 - Video tutorial

Model: Hyundai I20 MK 1, PB - Years 2008-2014
Part: Rear bumper
Operation: Removing the rear bumper Hyundai i20

To be able to disassemble the rear bumper, you will have to start by removing the rear lights: therefore open the rear hood, unscrew the fixing screws of the lights present along the closing line of the hood and extract them from their seats by disconnecting the lamp holders to complete the disassembly; the expansion stops and screws present in correspondence with the seat of the rear lights, along the edge of the wheel arch, of the edge of the bumper, along the lower edge of the bumper itself will then be removed by removing the support bracket which is located from the side of the muffler; at this point it is possible to move the bumper far enough away to disconnect the license plate lights and complete disassembly.


Posted on 12 December 2023 by ScegliAuto



Hyundai I20 rear bumper removal
Hyundai I20 (2014-2021 / IB, MK 2, GB) In today's video tutorial we will see how to remove the rear bumper of a second series Hyundai I20. First of all, let's unscrew all the fixing screws
How to remove the front bumper of a Hyundai I20
Hyundai I20 (2008-2014 / MK 1, PB) Let's see in this video how to remove the front bumper of a Hyundai I20. Let's lift the bonnet and put it in safety. With a plastic lever we remove t
How to remove the rear lights in the Hyundai I20?
Hyundai I20 (2014-2021 / IB, MK 2, GB) As we can see in this tutorial, removing the rear lights in the Hyundai I20 is an extremely simple and fast operation. Before proceeding, make sure t

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos