Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : How to remove the rear light on Hyundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 1, PA - Years 2007-2013
Part: Tail light
Operation: How to remove the rear light on Hyundai I10

We disassemble the rear light of the car if we want to replace it or replace the bulbs inside it. Lift the tailgate of the luggage compartment, unscrew the tightening screws on the side of the headlight with a screwdriver, remove the rear light from its housing once all the screws have been removed (disconnect the power supply terminals). We disassemble the damaged bulbs and replace them with new ones (size and voltage equal). After mounting the bulbs in the headlight, we connect the electrical clamps to the new headlight, screw in the clamping screws. We turn on and see the operation of the bulbs.


Posted on 21 December 2023 by ScegliAuto



How to disassemble the rear light and the bulb of the Hyundai I10
Hyundai I10 (2013-2020 / MK 2, IA) In this short guide, we will see the instructions necessary to disassemble and replace the rear light and its bulbs of the Hyundai I10, by following
How to use the tire inflation kit in the Hyundai I10
Hyundai I10 (2013-2020 / MK 2, IA) In today's video we see how to use the inflate and repair kit of the Hyundai I10. This device is supplied with the car instead of the spare wheel or
How to open the fuel door of the Hyundai i10.
Hyundai I10 (2013-2020 / MK 2, IA) As you can see very well in the video, opening the fuel door (gasoline) of your Hyundai I10 car is very simple. Unlike other cars where you simply pr

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos