Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I10
    4. : How to disassemble the rear light and the bulb of the Hyundai I10

Hyundai I10 - Video tutorial

Model: Hyundai I10 MK 2, IA - Years 2013-2020
Part: Tail light
Operation: How to disassemble the rear light and the bulb of the Hyundai I10

In this short guide, we will see the instructions necessary to disassemble and replace the rear light and its bulbs of the Hyundai I10, by following these simple steps. First of all let's move to the back of the car and open the rear tailgate of the trunk; then we unscrew the two fixing screws that we find on the sides of the light, as shown in the video. At this point gently remove the headlight, disconnecting the bulbs' electrical connector; therefore we replace the stop lights or directly the whole taillight, applying the reverse procedure for reassembly!


Posted on 15 December 2022 by ScegliAuto



How to replace the headlight bulb Hyundai I10
Hyundai I10 (2007-2013 / MK 1, PA) In this very simple video guide we will see how to remove the headlight bulb of a Hyundai I10. The disassembly operation takes a few minutes and is n
How to replace the headlight bulb on Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) To be able to replace the headlight bulb of the Hyundai I10 you have to open the hood to access the engine compartment and turn the protective cap of
How to replace the front fog light bulb of the 2013 Hyundai I10?
Hyundai I10 (2013-2020 / MK 2, IA) The replacement of the left fog light bulb on a Hyundai I10 vehicle involves short and simple steps that can be done independently. To replace the bu

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos