Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of Aftermarket H4 Xenon Kit

Model: Hyundai Accent RB, RC, MK 4 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Accessory kit

See other generations:
Video tutorial

Open the front bonnet and remove the protective cap from the bulb holder, disconnect the power connector, unclip the retaining spring, and extract the original bulb; to perform the same operation on the driver’s side headlamp, you will need to remove the headlamp mounting pins to gain a bit more manoeuvring space.

At this point, drill a hole in the centre of the bulb holder cap to pass the power cables for the new bulb and fit the grommet (use a step drill); then fit the new bulbs and secure the wiring, avoiding contact with hot or moving parts; properly house the ignition ballasts and make the necessary electrical connections.


Updated on 7 February 2026 by ScegliAuto


Related tutorials

How to replace the windscreen wiper blades on the Hyundai Accent?
How to replace the windscreen wiper blades on the Hyundai Accent?
Hyundai Accent (2005-2009 / MK 2, MC) To replace the windscreen wiper blades on the Hyundai Accent, lift the wipers so they are not in contact with the windscreen: once lifted, tilt them …
Front Shock Absorber Replacement
Front Shock Absorber Replacement
Hyundai Accent (1999-2005 / LC, MK 1) Lift the vehicle on suitable axle stands and remove the front wheel; then proceed to unscrew the mounting bolts of the shock absorber from the hub su…
Replacement of the Rocker Cover Gasket
Replacement of the Rocker Cover Gasket
Hyundai Accent (1999-2005 / LC, MK 1) The failure of the rocker cover gasket, resulting in oil leakage, is a fairly common defect but easily resolved. It is advisable to carry out this re…

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos