Do it yourself
Frequently asked questions about cars and motorcycles

How to Perform a Service on Hyundai IX20 LPG

Model: Hyundai ix20 OJ - Years 2010-2019
Part: Checks and maintenance

In this video tutorial, see how to perform a service on the Hyundai IX20. The first step is to purchase the necessary products (5W-40 oil, oil filter, air filter, cabin filter, LPG filter, and 4 spark plugs). Lift the car with a hydraulic jack and place safety stands underneath. Position a container for the used oil under the engine, and using a 17mm spanner, remove the oil drain plug, allowing all the oil to drain into the container. Once the oil has finished draining, replace the plug. Now, remove the oil filter and replace it with the new one (keep the old one under the container), lubricate the filter seal before fitting the new filter, and remember to tighten it by hand to prevent it from loosening. Next, top up the engine oil (5W-40) with approximately 3.5 litres. Check the oil level with the engine running and add more if necessary. Now, remove the LPG filter and cover, where the spark plug coils are located, using a 10mm spanner. Carefully pull off the spark plug leads (ensure you remember the order). Finally, unscrew the spark plugs.

Updated on 7 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Hyundai ix20 (2010-2019 / OJ) Replacing the battery on a Hyundai IX20 is a very simple task that you can do independently, aided by our short video tutorial. The first step is to …
Hyundai ix20 (2010-2019 / OJ) Replacing the right front headlight bulb on a 2013 Hyundai IX20 vehicle is a simple and quick operation to be carried out independently. To replace t…
Hyundai ix20 (2010-2019 / OJ) The steps to replace the battery of the 2017 Hyundai IX20 are simple and quick to do independently. The tools we will use to remove the battery are: …

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos