Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. Santa Fe
    4. : Front headlight disassembly instructions

Hyundai Santa Fe - Video tutorial

Model: Hyundai Santa Fe MK 2 - Years 2006-2012
Part: Headlight
Operation: Front headlight disassembly instructions

Removing the headlight is a very simple operation to perform, above all because you will not have to remove any other element such as the bumper; therefore, once the front bonnet has been lifted, it will be sufficient to unscrew the two upper fixing pins, those applied right on the bonnet striking crosspiece above the headlight itself and then the nut present at the innermost edge, towards the mat; once the fasteners have been removed, pull the headlight forward just enough to disconnect the rear power sockets and complete the disassembly; we will then proceed backwards for the installation.


Posted on 5 September 2023 by ScegliAuto



How do you remove the front headlight of the Hyundai Santa Fe?
Hyundai Santa Fe (2012-2018 / MK 3) In order to remove the front headlight of the Hyundai Santa Fe, you need to loosen all the screws that secure the front bumper to its housing: these
Removal of Hyundai Santa Fe headlight bulbs
Hyundai Santa Fe (2006-2012 / MK 2) Removing the headlight bulbs on a Hyundai Santa Fe, let's see how it is removed from the inside of the headlight. We open and lift the front hood. Wi
Disassembly and replacement of headlights
Hyundai Santa Fe (2000-2006 / MK 1) If you need to replace one or both of the headlights because they are damaged or not very bright, because the transparent plastic has become opaque,

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos