Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Cleaning and Lubricating the Brakes on a Hyundai Kona EV

Model: Hyundai Kona MK 1 - Years: 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: Checks and maintenance

See other generations:
Video tutorial

In this video, learn how to maintain the brakes on a Hyundai Kona EV. Start by removing the wheel, then detach the caliper by unscrewing the two bolts holding it in place. Place the caliper where the flexible hoses won't be damaged.

Next, remove the two metal clips and the worn brake pads along with the two metal supports. Clean these parts with an abrasive disc, ensuring to clean the entire caliper and base using the same method.

Apply some copper grease, even on the pads (which are not being replaced, only cleaned). Refit the metal clips and then the calipers, tightening them with their bolts.

Replace the wheel and repeat the process on the other side.


Updated on 21 September 2026 by ScegliAuto


Related tutorials

How to Reset the "Service" Light on a Hyundai Kona?
How to Reset the "Service" Light on a Hyundai Kona?
Hyundai Kona (2017-2023 / MK 1) Hello, this guide aims to reset the "Service" light on your Hyundai Kona. Start the vehicle's instrument panel by pressing the ignition button. Using…
Where is the OBD port located in the 2019 Hyundai Kona?
Where is the OBD port located in the 2019 Hyundai Kona?
Hyundai Kona (2017-2023 / MK 1) In this new guide, we will describe the few simple steps required to locate the OBD port in your first series Hyundai Kona (2019 model). First, enter…
Removing the Cabin Filter from the Hyundai Kona
Removing the Cabin Filter from the Hyundai Kona
Hyundai Kona (2017-2023 / MK 1) To remove the cabin air filter from the Hyundai Kona, first remove the glove compartment located in the dashboard. Open the glove compartment and unc…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos