|
Do it yourself
| |||
| ||||
Things to keep an eye on under the hood of an Iveco Daily 2.3 MK4
Model: IVECO Daily
MK 4
- Years:
2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Video tutorial
In this video, we will see what things to keep under control, under the hood of a Fiat Iveco Daily MK4, to always have it in perfect efficiency. The first thing we see on the right side of the engine compartment, which we have opened in the meantime, is the windshield washer fluid container, which must always be kept full, with a mixture of demineralized water and the appropriate liquid. In the middle, we have the air filter and the brake fluid container. Remember that brake fluid theoretically does not get consumed: if it does, it is because the brake pads are worn out, so we add a little fluid but remember to have the brakes checked. Just below there is the dipstick for checking the engine oil level. We will pull it out, clean it, put it back in, and then check that the level is close to the maximum level line. On the right side, we find the battery. The power steering is instead on the opposite side, near the right wheel arch: here too we must check the fluid level.
Posted on 19 March 2025 by ScegliAuto
Related tutorials
IVECO Daily
(2006-2020 /
MK 4)
Replacing the cabin air filter on your Iveco Daily is a very important task and should be done periodically. In this guide, discover the various step…
IVECO Daily
(2006-2020 /
MK 4)
The OBD port on an Iveco Daily vehicle is located inside the cabin; specifically, the port is installed next to the fuse box located behind the drive…
IVECO Daily
Through this very short video tutorial, you can see the diagram of the main fuse box for an Iveco Daily, a model produced from 2000 to 2006. The diag…
Other guides you may be interested in
|
How to Extract the Spare Wheel from a Mercedes Vito
The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.181
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |