Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to reset the service light on the Iveco Daily

Model: IVECO Daily MK 5 - Years 2014-2026
Part: Service warning light

Below we will see the procedure on how to reset the service light for the routine maintenance of the oil change on the Iveco Daily. First, we get on board the cabin and start by turning on the instrument panel; then we press and hold the accelerator pedal, while pressing the brake pedal ten times simultaneously, as shown in the video. At this point, turn off the instrument panel, wait about ten seconds before turning everything back on; check that the service light has been reset correctly by the instrument panel!

Posted on 11 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to reset the service light on the Iveco Daily 4
How to reset the service light on the Iveco Daily 4
IVECO Daily (2006-2020 / MK 4) Restoring the maintenance interval on an Iveco Daily mk4 model vehicle is a simple and quick operation to be carried out independently. To reset the …
How to Replace the Headlamp Bulb on an Iveco Daily?
How to Replace the Headlamp Bulb on an Iveco Daily?
IVECO Daily (2006-2020 / MK 4) To replace the headlamp bulb of the external rear-view mirror on the Iveco Daily, use a flat screwdriver to lever inside the groove formed between th…
How to reset the service of the Iveco Daily 2011
How to reset the service of the Iveco Daily 2011
IVECO Daily (2006-2020 / MK 4) In this video, we see how to reset the service light on a 2011 Iveco Daily. We need to turn on the dashboard - make sure the doors, front hood, and p…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos