Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on a 2012 Iveco Daily?

Model: IVECO Daily MK 4 - Years: 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017
Part: Service warning light

See other generations:
Video tutorial

The service for your vehicle, in this case, the 2012 Iveco Daily, can also be done DIY, as shown in the attached video. The operations are well known, including oil change, oil filter, etc., which must be accompanied by resetting the service light to set the next scheduled maintenance date.

To cancel the warning, turn on the instrument panel, hold down the accelerator pedal, press the brake pedal ten times consecutively, release both, and then turn off the instrument panel.


Posted on 8 June 2026 by ScegliAuto


Related tutorials

How to Reset the Oil Service Light on an Iveco Daily?
How to Reset the Oil Service Light on an Iveco Daily?
IVECO Daily (2006-2020 / MK 4) To reset the Oil Service light on an Iveco Daily, turn the key to switch on the instrument panel, ensuring the light is illuminated. To reset it, pre…
How to reset the Service light on the Iveco Daily?
How to reset the Service light on the Iveco Daily?
IVECO Daily To reset the Service light on the Iveco Daily, turn the key to switch on the instrument panel, confirming that the light is on. To reset it, press an…
How to Reset the Service Light on the Iveco Daily?
How to Reset the Service Light on the Iveco Daily?
IVECO Daily To reset the Service light on the Iveco Daily, press the accelerator pedal while the vehicle is completely off: while holding it down, turn the key i…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos