Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the touch screen on a Jeep Cherokee

Model: Jeep Grand Cherokee WK2, MK 4 - Years 2010-2021
Part: Onboard computer

Here’s some good news: replacing the touch screen (or onboard computer) on this model is extremely simple, much more so than usual. You can remove the surrounding panel (which contains the air vents, climate control, and radio controls) by simply opening the lower glove compartment and pulling it out with your hands, then leveraging around the surrounding gap with a plastic wedge. Disconnect the connector and move on to the screen, where you will need to unscrew the four 7 mm screws located at its corners.

Updated on 8 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the onboard computer in the Jeep Grand Cherokee?
How to reset the onboard computer in the Jeep Grand Cherokee?
Jeep Grand Cherokee (2004-2010 / WK, MK 3, WH) In this tutorial, we can see how to reset the onboard computer in the Jeep Grand Cherokee, an extremely simple and quick operation to be carried out,…
How to Reset the Screen on the Jeep Grand Cherokee?
How to Reset the Screen on the Jeep Grand Cherokee?
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) If you notice that the touch display of the onboard computer in your car does not turn on and does not allow any operations, the following descriptio…
How to Perform a Factory Reset of the System in a Jeep Grand Cherokee
How to Perform a Factory Reset of the System in a Jeep Grand Cherokee
Jeep Grand Cherokee (2010-2021 / WK2, MK 4) To perform a factory reset of the Uconnect multimedia system in a fourth-generation Jeep Grand Cherokee, turn on the ignition and the central display…

Other guides you may be interested in

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos